PRE-DELIVERY INSPECTION

id000000801100

Refer To The Workshop Manual For Detailed Adjustment Procedures

• The steps in this inspection sheet are designed for efficient movement around the vehicle.

• Problems found during inspection should be noted on a repair order.

• Unless otherwise stated, each item should be inspected for fit, appearance and/or operation.

• Inspection items followed by an asterisk (*) are required only if the vehicle is equipped with that feature.

Pre-Delivery Inspection Table

General

qCheck vehicle for any open Recalls, SSPs, or MSPs, and available updates for audio/navigation systems

qInstall/assemble all loose or packaged parts in the glove box and trunk/cargo area

Exterior

INSPECT and ADJUST, if necessary, the following items to specification:

qREMOVE all protective wrap, covers, and window stickers

• Unless the vehicle is scheduled for display or immediate delivery, do not remove the exterior protective film or interior protective covering during inspection

qGlass, exterior bright metal and paint for damage

qDoor and liftgate* operation (Open/Close)

qAll weather strips for damage or detachment

qSecurity/keyless entry devices (Doors locking/unlocking by transmitter)*

qAdvanced keyless entry (Doors locking/unlocking by request switches)*

qOperation of bonnet release and lock, trunk release*, and fuel-filler lid opener

qPour one bottle of deposit cleaner into the fuel tank (Specified countries only)

• Refuel the vehicle after adding the deposit cleaner or inform the customer to do so immediately

• For details on the specified countries, please refer to the service information

Under bonnet-engine off

INSPECT and ADJUST, if necessary, the following items:

qINSTALL Fuses for accessories

• ROOM fuse

• AUDIO fuse

qFuel, engine coolant, and hydraulic lines, fittings, connections, and components for leaks

qEngine oil level

qBrake/clutch fluid level

qWindshield washer reservoir fluid level

qRadiator coolant level

qTightness of battery terminals, electrolyte level and voltage (12.4 V)

qCheck the electrolyte specific gravity in case models with i-stop system or i-ELOOP*

Record the voltage and electrolyte specific gravity in the table below.

? If the cell with the lowest specific gravity is less than 1.17, replace the battery

? If the cell with the lowest specific gravity is 1.17 or more, recharge the battery, after charging if the cell with the lowest specific gravity is less than 1.25, replace the battery.

Please refer to the Service-Information (E039/12A) to get the detail battery inspection procedure.

Record Battery Voltage / Electrolyte specific gravity
Open circuit voltage (V)	V / (after charge V)
Specific Gravity	No.1	No.2	No.3	No.4	No.5	No.6
Before charging
After charging

Interior

INSPECT the operations of the following items:

qSecure floor mats to hooks.

qParking brake

qVerify that warning lights (check engine, brake, engine oil, charging system, ABS, TPMS) stay on for a few seconds after engine start

qMazda ERA-GLONASS control module finalization (If the indicator of the Mazda ERA-GLONASS switch is turned on/flashes)

Leave Engine Idling In Park Until Reaching Operating Temperature

qHorn, front/rear wipers, and washers. Wiper blades performance (Clean wiper blades and windshield, if necessary).

qHeadlight cleaner (Washer fluid injection)*

qInterior and exterior lights, dash switches, headlight leveling switch. (Set position to 0)*

qAudio system (Power/Volume/sound controls, Radio, CD player, including steering wheel audio controls)

qHeater and A/C (driver, passenger) and front defroster in all mode settings

qTurn on navigation system. (Present location indication)*

qAdjust clock, dash panel and navigation system*

qPower window initialization (if battery was discharged during inventory storage).

qDoor locks

INSPECT the following items:

qUpholstery and interior finish

qCheck operation of any dealer installed accessories

Turn Engine Off And raise Vehicle On Lift

ON hoist

INSPECT the following items:

qREMOVE under cover

qTires for cuts or bruises

qUnderside fuel, coolant and hydraulic lines, fittings, connections, and components for leaks

qSteering linkage, suspension, exhaust system, and all underside hardware for looseness or damage

qINSTALL under cover

Lower Vehicle And Remove From Lift

qTire pressures (See tire label located on driver’s side B-pillar or edge driver’s of door frame for specification.)

qInitialize the TPMS*. Switch the ignition ON, then press and hold TPMS SET switch until the TPMS warning light and one beep flashes twice is heard.

qSpare Tire pressures (See tire label located on driver’s side B-pillar or edge driver’s of door frame for specification.)*

qFlat tire repair kit*

Tire pressure record
Left front	Right front	Left rear	Right rear	Spare

Indicated that long-pressing of the tire pressure monitoring system set switch was implemented

Yes or No

Road test-engine running at operating temperature

INSPECT the following items:

qSteering operation (steering wheel centered, drift or pull, and power assist)

qBrake operation

qEngine general performance

qSqueaks, rattles, and abnormal noises

qWarning lights are off

qVerify navigation system receives GPS signal (vehicle follows map)*

After road test

The following items must be completed just before delivery to your customer.

qTire pressures (See tire label located on driver’s side B-pillar or edge driver’s of door frame for specification.)

qInitialize the TPMS*. Switch the ignition ON, then press and hold TPMS SET switch until the TPMS warning light and one beep flashes twice is heard.

Note

• Only when the condition TPMS initialization required. Refer to the Work Shop Manual.

Tire pressure record
Left front	Right front	Left rear	Right rear	Spare

Indicated that long-pressing of the tire pressure monitoring system set switch was implemented

Yes or No

qAfter washing and drying the vehicle, perform appearance checks before delivery

APPEARANCE CHECKS BEFORE DELIVERY
In addition to function checks, also perform one last inspection of key areas of the vehicle to ensure they are clean and free of chips and scratches.
Check and repair chips and scratches:	Remove dirt and Scratches from key areas:
qDoor edges qAround door handles qDoor dings and dents qBonnet leading edges qBumper covers	qDoor sill scuff plates qDoor inner panel qSeats qCarpets and floor mats qSteering wheel qCenter console