ENGINE OIL PRESSURE SENSOR INSPECTION [SKYACTIV-G 2.5T]

id0140h0216900

Voltage Inspection

Note

•  The engine oil pressure sensor and engine oil temperature sensor cannot be removed as a single unit. When replacing the engine oil pressure sensor, replace the engine oil pressure sensor/engine oil temperature sensor.

1.  Switch the ignition ON (engine off).

2.  Measure the voltage at the engine oil pressure sensor/engine oil temperature sensor terminal D.

ac9uuw00007679

•  If the voltage is within the specification, go to the next step.

•  If the voltage is not within the specification, replace the engine oil pressure sensor/engine oil temperature sensor. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)

3.  Connect the M-MDS to the DLC-2.

4.  Start the engine.

5.  Access the PID/DATA monitor item OIL_PRES using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].)

6.  Measure the voltage at the engine oil pressure sensor/engine oil temperature sensor terminal D when the OIL_PRES PID increases.

•  If the voltage does not increase, replace the engine oil pressure sensor/engine oil temperature sensor. (See ENGINE OIL PRESSURE SENSOR/ENGINE OIL TEMPERATURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)

Specification (Reference)

ac9uuw00007680