HIGH FUEL PRESSURE SENSOR INSPECTION [SKYACTIV-G 2.5T]

id0140h0540100

Voltage Inspection

Note

•  The high fuel pressure sensor cannot be removed as a single unit. When replacing the high fuel pressure sensor, replace it together with the fuel distributor as a single unit.

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Start the engine and warm it up completely.

4.  Verify that the high fuel pressure sensor output voltage (PID: FUEL_PRES) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

•  If not within the specification, replace the fuel distributor. (See FUEL INJECTOR REMOVAL/INSTALLATION [SKYACTIV-G 2.5T].)

Specification (Reference)

ac9uuw00007686