COUPLING COMPONENT CALIBRATION DATA WRITING

id031800806200

1.  Connect the M-MDS to the DLC-2.

2.  After the vehicle is identified, select the following items from the toolbox of the M-MDS.

1.  Select “Chassis”.

3.  Then, select items from the screen menu in the following order.

1.  Select “4WD/AWD”.

2.  Select “Coupling Calibration Data Writing”.

4.  Perform the configuration according to the directions on the screen.

Caution

•  When the configuration is performed, CAN communication between the 4WD control module and control module connected to the CAN line is cut temporarily, and communication error DTCs may be detected. After performing the configuration, verify the DTCs for the control module connected to the CAN line and clear it if any DTC is detected.

5.  Verify all the DTCs for the control module connected to the CAN line.

•  If any DTC is stored, clear it.

•  If the DTC is cleared, finish the procedure because the configuration is completely normally.

•  If the DTC remains, perform troubleshooting according to the DTC.