ABNORMAL NOISE WHILE THE DOOR GLASS IS OPENING OR CLOSING [POWER WINDOW SYSTEM]

id0903a0995800

Description
Abnormal noise while the door glass is opening or closing
Possible Causes
•  Installation screw is loose between the door glass and carrier plate.
•  Deformity in the power window regulator plastic part due to use.
?  Scratching, wear marks to the power window regulator resin part due to twisting of the cable.
?  Gear deformity in the power window motor.
Note
•  Identify the location of the noise using a stethoscope or similar device.

Diagnostic procedure

Noise type

Time of occurrence

Possible cause

Location of noise

Action
Clanking noise
Door glass begins to move
Insufficiently tightened installation screw between the door glass and carrier plate.
Between door glass lower edge and carrier plate.
Securely tighten the installation screw.
Groaning noise
(Sound increases due to use)
While door glass is operating
Vibration caused by wear on the resin part from cable twisting due to use of the power window regulator.
Note
•  Noise does not occur if a roller is equipped to power window regulator resin part.
Power window regulator
Replace the power window regulator
(See FRONT POWER WINDOW REGULATOR REMOVAL/INSTALLATION.)
(See REAR POWER WINDOW REGULATOR REMOVAL/INSTALLATION.)
Whining noise
Gear inside power window motor is deformed due to use.
Gear in power window motor
Replace the power window motor
(See FRONT POWER WINDOW MOTOR REMOVAL/INSTALLATION.)
(See REAR POWER WINDOW MOTOR REMOVAL/INSTALLATION.)
Clicking noise
(Periodic noise)

ac5wzw00003122