POWER BRAKE UNIT VACUUM SENSOR INSPECTION [SKYACTIV-G 2.5T]

id0140h0889400

With i-stop system

Voltage inspection

1.  Connect the M-MDS to the DLC-2.

2.  Switch the ignition ON (engine off).

3.  Verify that the power brake unit vacuum sensor output voltage (PID: BBP) is within the specification. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)].) (See PCM INSPECTION [SKYACTIV-G 2.5T].)

•  If not as specified, replace the power brake unit vacuum sensor. (See POWER BRAKE UNIT REMOVAL/INSTALLATION [L.H.D.].) (See POWER BRAKE UNIT REMOVAL/INSTALLATION [R.H.D.].)

Specification (Reference)

ac9wzw00003865