DTC U0300:00 [INSTRUMENT CLUSTER (DIRECT TPMS (WITHOUT TPMS SET SWITCH))]

id020212801600

DTC
U0300:00
Instrument cluster configuration error
DETECTION CONDITION
•  Instrument cluster configuration error detected as follows:
?  No configuration of instrument cluster
?  Instrument cluster configuration has not been correctly performed.
FAIL-SAFE FUNCTION
•  Refer to “Fail-safe function table”. (See DTC TABLE [INSTRUMENT CLUSTER (DIRECT TPMS (WITHOUT TPMS SET SWITCH))].)
POSSIBLE CAUSE
•  Instrument cluster configuration error
•  Instrument cluster malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA)
•  Using the M-MDS, perform the instrument cluster configuration with the As-Built data.
•  Clear DTC for the instrument cluster using the M-MDS.
•  Perform the DTC inspection for the instrument cluster using the M-MDS.
•  Is DTC U0300:00 displayed?
Yes
Using the M-MDS, re-perform the instrument cluster configuration using the As-Built data, then go to the next step.
(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)
No
Go to Step 3.
2
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear DTC for the instrument cluster using the M-MDS.
•  Perform the DTC inspection for the instrument cluster using the M-MDS.
•  Is DTC U0300:00 displayed?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [INSTRUMENT CLUSTER (DIRECT TPMS (WITHOUT TPMS SET SWITCH))].)
No
DTC troubleshooting completed.