DTC C0001:01/C0001:49/C0003:01/C0003:49 [DSC HU/CM]
id040262845100
|
DTC
|
C0001:01
|
Stability control solenoid valve
|
|
C0001:49
|
||
|
C0003:01
|
||
|
C0003:49
|
||
|
DETECTION CONDITION
|
• Stability control solenoid valve malfunction is detected.
|
|
|
FAIL-SAFE FUNCTION
|
• Refer to “Fail-safe function table”. (See DTC TABLE [DSC HU/CM].)
|
|
|
POSSIBLE CAUSE
|
• DSC HU/CM malfunction
|
|
|
SYSTEM WIRING DIAGRAM
|
Not applicable
|
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY STABILITY CONTROL SOLENOID VALVE OPERATION
• Using the M-MDS, perform the simulation inspection for stability control solenoid valve.
• Does the solenoid valve operate?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the DSC HU/CM, then go to the next step.
|
||
|
2
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Using the M-MDS, clear the DTC from the DSC HU/CM.
(See CLEARING DTC [DSC HU/CM].)
• Using the M-MDS, perform the DSC HU/CM DTC inspection.
(See DTC INSPECTION [DSC HU/CM].)
• Is the same DTC present?
|
Yes
|
Repeat the inspection from Step1.
If the malfunction recurs, replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
3
|
VERIFY NO DTC IS PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
(See DTC TABLE [DSC HU/CM].)
|
|
No
|
DTC troubleshooting completed.
|
||