STARTER DOES NOT WORK [GW6A-EL, GW6AX-EL]
id050320102900
|
TROUBLESHOOTING ITEM |
Starter does not work |
|---|---|
|
DESCRIPTION
|
• Starter does not work even when in P or N position.
|
|
POSSIBLE CAUSE
|
1. Wiring harness between TCM terminal J and PCM terminal 2BD malfunction
2. Wiring harness between TCM terminal J and start stop unit terminal 1F malfunction
3. Wiring harness between start stop unit terminal 2H and LF control unit terminal G malfunction (With advanced keyless entry system)
4. Immobilizer system operating or system malfunction
5. Engine control system malfunction
|
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
INSPECT WIRING HARNESS BETWEEN TCM AND PCM
• Switch the ignition off.
• Disconnect the PCM connector and TCM connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and PCM terminal 2BD.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT WIRING HARNESS BETWEEN TCM AND START STOP UNIT
• Disconnect the start stop unit connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between TCM terminal J and start stop unit terminal 1F.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Without advanced keyless entry system:
• Go to step 4.
With advanced keyless entry system:
• Go to the next step.
|
||
|
3
|
INSPECT WIRING HARNESS BETWEEN TCM AND LF CONTROL UNIT
• Disconnect the LF control unit connector.
• Visually inspect for pin deformity, open circuit, or wiring harness non-insulation between start stop unit terminal 2H and LF control unit terminal G.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Go to the next step.
|
||
|
4
|
INSPECT IMMOBILIZER SYSTEM AND ENGINE CONTROL SYSTEM FOR MALFUNCTION
• Perform the symptom troubleshooting “NO.3 WILL NOT CRANK”.
• Is there any malfunction?
|
Yes
|
Repair or replace any malfunctioning parts according to the inspection result.
|
|
No
|
Symptom troubleshooting is completed.
|
||