SECURITY INDICATOR LIGHT: 15, DTC: B13D3:51/P1260:00 [START STOP UNIT]

id0902p6028000

Description

Unregistered remote transmitter is detected
Detection condition
•  Start stop unit detects that the remote transmitter has not been programmed.
Fail-safe
Not applicable
Possible cause
•  Remote transmitter malfunction
?  The remote transmitter is not programmed after replacing the start stop unit.
?  Unprogrammed remote transmitter was used.
•  Start stop unit malfunction
System wiring diagram
Not applicable

Diagnostic Procedure

Step

Inspection

Action
1
VERIFY IF REMOTE TRANSMITTER BROUGHT INTO VEHICLE IS FOR THAT VEHICLE
•  Does the remote transmitter belong to another vehicle?
Yes
Have the correct remote transmitter for the vehicle ready inside the vehicle, then go to Step 3.
No
Go to the next step.
2
VERIFY IF MALFUNCTIONING LOCATION IS REMOTE TRANSMITTER DEPENDING ON REPEATABILITY
•  Clear the DTC for the start stop unit using the M-MDS.
•  Program key ID number of the remote transmitter.
•  Retrieve the start stop unit DTCs using the M-MDS.
•  Is the security indicator light: 15, DTC B13D3:51/P1260:00 displayed?
Yes
Replace the malfunctioning remote transmitter, then go to the next step.
(See IMMOBILIZER SYSTEM-RELATED PARTS PROGRAMMING.)
No
Go to Step 4.
3
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear the DTC for the start stop unit using the M-MDS.
•  Retrieve the start stop unit DTCs using the M-MDS.
•  Is the security indicator light: 15, DTC B13D3:51/P1260:00 displayed?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the start stop unit.
Go to the next step.
No
Go to the next step.
4
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [START STOP UNIT].)
No
DTC troubleshooting completed.