DTC U2300:64 [BLIND SPOT MONITORING (BSM) CONTROL MODULE]

id1502b5015600

Description

Instrument cluster configuration error
Detection condition
•  Instrument cluster configuration error (signal error) detected.
Fail-safe
•  Blind spot monitoring (BSM) system is stopped.
Possible cause
Note
•  To correctly write the configuration data sent from the instrument cluster to the blind spot monitoring (BSM) control module to the blind spot monitoring (BSM) control module, 30 s or more need to have elapsed since the ignition was switched ON (engine off or on).
•  Instrument cluster configuration error
•  blind spot monitoring (BSM) control module malfunction
System wiring diagram
Not applicable

Diagnostic Procedure

Step

Inspection

Action
1
PERFORM INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA)
•  Using the M-MDS, perform the instrument cluster configuration (using As-Built data).
•  Clear the DTC for the blind spot monitoring (BSM) control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 30 s or more.
•  Retrieve the blind spot monitoring (BSM) control module DTCs using the M-MDS.
•  Is the same DTC displayed?
Yes
Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step.
(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)
No
Go to Step 3.
2
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear the DTC for the blind spot monitoring (BSM) control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 30 s or more.
•  Retrieve the blind spot monitoring (BSM) control module DTCs using the M-MDS.
•  Is the same DTC displayed?
Yes
Replace the blind spot monitoring (BSM) control module, then go to the next step.
(See BLIND SPOT MONITORING (BSM) CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [BLIND SPOT MONITORING (BSM) CONTROL MODULE].)
No
DTC troubleshooting completed.