DTC P073D:00 [TCM (GW6A-EL, GW6AX-EL)]

id0502o9905700

DTC P073D:00

Neutral incorrect ratio
DETECTION CONDITION
•  In P or N position, the following phenomenon occurs:
?  Speed ratio is 0.5 or less for 2 s while vehicle is stopped in P or N position.
FAIL-SAFE FUNCTION
Not applicable
POSSIBLE CAUSE
•  Clutch stuck
•  Turbine/input shaft speed sensor malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY DTC OUTPUT STATUS
•  Are any the following DTCs displayed?
?  P0706:00, P0707:00, P0708:00, P0715:00, P0716:00, P0717:00
Yes
Go to the applicable DTC inspection.
(See ON-BOARD DIAGNOSTIC SYSTEM DTC TABLE [TCM (GW6A-EL, GW6AX-EL)].)
No
Replace the automatic transaxle.
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6A-EL].)
(See AUTOMATIC TRANSAXLE REMOVAL/INSTALLATION [GW6AX-EL].)