DTC U2300:55 [POWER LIFTGATE (PLG) CONTROL MODULE]

id0902o8082300

Description

Instrument cluster configuration not implemented
Detection condition
•  The power liftgate (PLG) control module received a signal which indicates the instrument cluster configuration is not performed.
Fail-safe
•  Stops the power liftgate (PLG) system operation.
Possible cause
Note
•  To correctly write the configuration data sent from the instrument cluster to the power liftgate (PLG) control module to the power liftgate (PLG) control module, 30 s or more need to have elapsed since the ignition was switched ON (engine off or on).
•  Instrument cluster configuration is not completed.
•  Instrument cluster malfunction
•  Power liftgate (PLG) control module malfunction
System wiring diagram
Not applicable

Diagnostic Procedure

Step

Inspection

Action
1
VERIFY IF OTHER DTCs DISPLAYED FOR POWER LIFTGATE (PLG) CONTROL MODULE
•  Clear the DTC for the power liftgate (PLG) control module using the M-MDS.
•  Retrieve the power liftgate (PLG) control module DTCs using the M-MDS.
•  Is DTC U3000:49 displayed?
Yes
Replace the power liftgate (PLG) control module, then go to step 4.
(See POWER LIFTGATE (PLG) CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
2
VERIFY ALL SYSTEM DTCs
•  Clear the DTC for the power liftgate (PLG) control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 30 s or more.
•  Perform a CMDTC self-test using the M-MDS.
•  Are there any modules other than the power liftgate (PLG) control module displaying DTC U2300:55?
Yes
Using the M-MDS, perform the instrument cluster configuration (using As-Built data) again, then go to the next step.
(See INSTRUMENT CLUSTER CONFIGURATION (USING AS-BUILT DATA).)
No
Go to Step 4.
3
VERIFY ALL SYSTEM DTCs AGAIN
•  Clear the DTC for the power liftgate (PLG) control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 30 s or more.
•  Perform a CMDTC self-test using the M-MDS.
•  Are there any modules other than the power liftgate (PLG) control module displaying DTC U2300:55?
Yes
Replace the instrument cluster, then go to the next step.
(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
No
Go to the next step.
4
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
•  Clear the DTC for the power liftgate (PLG) control module using the M-MDS.
•  Switch the ignition ON (engine off or on) and wait for 30 s or more.
•  Retrieve the power liftgate (PLG) control module DTCs using the M-MDS.
•  Is the same DTC displayed?
Yes
Replace the power liftgate (PLG) control module, then go to the next step.
(See POWER LIFTGATE (PLG) CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
5
VERIFY IF OTHER DTCs DISPLAYED
•  Are any other DTCs displayed?
Yes
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [POWER LIFTGATE (PLG) CONTROL MODULE].)
No
DTC troubleshooting completed.