DTC B1207:09 [MAZDA ERA-GLONASS CONTROL MODULE]

id0902r6059700

Description	SAS control module collision judgement system malfunction
Detection condition	• The Mazda ERA-GLONASS control module receives a collision determination system error signal from the SAS control module via hard wire 10 times continuously with the ignition switched ON (engine off or on).
Fail-safe function	Not applicable
Possible cause	• SAS control module detected the collision judgement system malfunction • SAS control module malfunction • Mazda ERA-GLONASS control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY SAS CONTROL MODULE DTCs • Retrieve the SAS control module DTCs using the M-MDS. (See DTC INSPECTION [SAS CONTROL MODULE].) • Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [SAS CONTROL MODULE].)
1		No	Go to the next step.
2	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear the DTC for the Mazda ERA-GLONASS control module using the M-MDS. (See CLEARING DTC [MAZDA ERA-GLONASS CONTROL MODULE]) • Switch the ignition ON (engine off or on) and wait for 25 s or more. • Perform the DTC inspection for the Mazda ERA-GLONASS control module using the M-MDS. (See DTC INSPECTION [MAZDA ERA-GLONASS CONTROL MODULE]) • Is the same DTC displayed?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the Mazda ERA-GLONASS control module. (See MAZDA ERA-GLONASS CONTROL MODULE REMOVAL/INSTALLATION.) Go to the next step.
2		No	Go to the next step.
3	VERIFY OTHER DTCs • Are any other DTCs displayed?	Yes	Repair the malfunctioning location according to the applicable DTC troubleshooting. (See DTC TABLE [MAZDA ERA-GLONASS CONTROL MODULE])
3	VERIFY OTHER DTCs • Are any other DTCs displayed?	No	DTC troubleshooting completed.