DTC U0513:68 [BLIND SPOT MONITORING (BSM) CONTROL MODULE]
id1502b5100500
|
Description |
Error signal received from DSC HU/CM |
|---|---|
|
Detection condition
|
• Blind spot monitoring (BSM) control module receives the error signal from the DSC HU/CM for 1 s or more.
|
|
Fail-safe
|
• Blind spot monitoring (BSM) system is stopped.
|
|
Possible cause
|
• DTCs are stored in the DSC HU/CM.
• DSC HU/CM malfunction
• Blind spot monitoring (BSM) control module malfunction
|
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY DSC HU/CM DTCs
• Retrieve the DSC HU/CM DTCs using the M-MDS.
(See DTC INSPECTION [DSC HU/CM].)
• Are any DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
(See DTC TABLE [DSC HU/CM].)
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY IF MALFUNCTIONING LOCATION IS DSC HU/CM DEPENDING ON REPEATABILITY
• Clear the DTC for the blind spot monitoring (BSM) control module using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 1 s or more.
• Retrieve the blind spot monitoring (BSM) control module DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to Step 4.
|
||
|
3
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the DTC for the blind spot monitoring (BSM) control module using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 1 s or more.
• Retrieve the blind spot monitoring (BSM) control module DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Replace the blind spot monitoring (BSM) control module, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
||