DTC B115E:54 [360°VIEW MONITOR CONTROL MODULE]
id1502c7054600
|
Description |
Aiming not performed |
|---|---|
|
Detection condition
|
• The 360°view monitor control module detects camera aiming has not been performed.
|
|
Fail-safe
|
• Projected vehicle path lines and fixed lines for each view are not displayed
• Icons for cameras not aimed are indicated in area where vehicle image is displayed
|
|
Possible cause
|
• Aiming is not performed (VIN mismatch)
• 360°view monitor control module malfunction
|
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY OTHER 360°VIEW MONITOR CONTROL MODULE DTCs
• Clear the DTC for the 360°view monitor control module using the M-MDS.
• Retrieve the 360°view monitor control module DTCs using the M-MDS.
• Is DTC U3000:41 or U3000:49 displayed?
|
Yes
|
Replace the 360°view monitor control module, then go to Step 3.
|
|
No
|
Go to the next step.
|
||
|
2
|
IDENTIFY CAMERA NOT AIMED
• Verify the vehicle image displayed in the center display.
• Verify which of the following cameras have not been aimed by the location of its icon in the display.
|
—
|
Icons for cameras not aimed are displayed in all positions
• Perform 360°view monitor system aiming.
Icons for any camera not aimed are displayed at the position
• Perform corresponding camera aiming or 360°view monitor system aiming.
Go to the next step.
|
|
3
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the DTC for the 360°view monitor control module using the M-MDS.
• Retrieve the 360°view monitor control module DTCs using the M-MDS.
• Is the same Pending DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the 360°view monitor control module.
Go to the next step.
|
|
No
|
Go to the next step.
|
||
|
4
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair or replace the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
||