DTC U3000:95 [360°VIEW MONITOR CONTROL MODULE]

id1502c7056400

Description	VIN mismatch
Detection condition	• 360°view monitor control module detects the following information does not match. ? VIN stored in EEPROM of 360°view monitor control module ? VIN sent from instrument cluster
Fail-safe	• Projected vehicle path lines and fixed lines for each view are not displayed • Icons for cameras not aimed are indicated in area where vehicle image is displayed
Possible cause	• The 360°view monitor control module is installed on a different vehicle. • DTCs are stored in the instrument cluster. • instrument cluster malfunction • 360°view monitor control module malfunction
System wiring diagram	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY IF 360°VIEW MONITOR CONTROL MODULE WAS INSTALLED ON DIFFERENT VEHICLE • Verify if the 360°view monitor control module was installed on a different vehicle. • Was the 360°view monitor control module installed on a different vehicle?	Yes	Go to the next step.
1		No	Go to Step 3.
2	READ VEHICLE INFORMATION SENT FROM INSTRUMENT CLUSTER TO 360°VIEW MONITOR CONTROL MODULE • After switching the ignition off, switch the ignition ON (engine off or on) again. • Clear the DTC for the 360°view monitor control module using the M-MDS. (See CLEARING DTC [360°VIEW MONITOR CONTROL MODULE].) • Switch the ignition ON (engine off or on) and wait for 1.5 s or more. • Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE].) • Is the same Pending DTC present?	Yes	Go to the next step.
2		No	Go to Step 6.
3	VERIFY INSTRUMENT CLUSTER DTCs • Retrieve the instrument cluster DTCs using the M-MDS. (See DTC INSPECTION [INSTRUMENT CLUSTER].) • Are any DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [INSTRUMENT CLUSTER].)
3		No	Go to the next step.
4	VERIFY IF MALFUNCTIONING LOCATION IS INSTRUMENT CLUSTER DEPENDING ON REPEATABILITY • Clear the DTC for the 360°view monitor control module using the M-MDS. (See CLEARING DTC [360°VIEW MONITOR CONTROL MODULE].) • Switch the ignition ON (engine off or on) and wait for 1.5 s or more. • Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE].) • Is the same Pending DTC present?	Yes	Replace the instrument cluster, then go to the next step. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)
4		No	Go to Step 6.
5	VERIFY THAT REPAIRS HAVE BEEN COMPLETED • Clear the DTC for the 360°view monitor control module using the M-MDS. (See CLEARING DTC [360°VIEW MONITOR CONTROL MODULE].) • Retrieve the 360°view monitor control module DTCs using the M-MDS. (See DTC INSPECTION [360°VIEW MONITOR CONTROL MODULE].) • Is the same Pending DTC present?	Yes	Repeat the inspection from Step 1. • If the malfunction recurs, replace the 360°view monitor control module. (See 360°VIEW MONITOR CONTROL MODULE REMOVAL/INSTALLATION.) Go to the next step.
5		No	Go to the next step.
6	VERIFY IF OTHER DTCs DISPLAYED • Are any other DTCs displayed?	Yes	Repair or replace the malfunctioning part according to the applicable DTC troubleshooting. (See DTC TABLE [360°VIEW MONITOR CONTROL MODULE].)
6		No	DTC troubleshooting completed.