DTC P2610:00 [PCM (SKYACTIV-G 2.5T)]
id0102s8303800
DTC P2610:00 |
Malfunction in instrument cluster |
---|---|
DETECTION CONDITION
|
• Malfunction detected in instrument cluster.
Diagnostic support note
• This is a continuous monitor (CCM).
• The check engine light illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM. (The check engine light may be illuminated depending on the malfunction conditions.)
• PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
• FREEZE FRAME DATA/Snapshot data is available.
• DTC is stored in the PCM memory.
|
FAIL-SAFE FUNCTION
|
• The fast idle up correction for the drive-by-wire control is inhibited.
|
POSSIBLE CAUSE
|
• Instrument cluster power supply circuit malfunction (in this case, the instrument cluster records DTC U3003:16.)
• Instrument cluster malfunction
• PCM malfunction
|
SYSTEM WIRING DIAGRAM
|
• Not applicable
|
Diagnostic Procedure
STEP |
INSPECTION |
ACTION |
|
---|---|---|---|
1
|
RECORD VEHICLE STATUS AT TIME OF DTC DETECTION TO UTILIZE WITH REPEATABILITY VERIFICATION
• Record the FREEZE FRAME DATA/snapshot data on the repair order.
|
—
|
Go to the next step.
|
2
|
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
• Verify related Service Information availability.
• Is any related Service Information available?
|
Yes
|
Perform repair or diagnosis according to the available Service Information.
• If the vehicle is not repaired, go to the next step.
|
No
|
Go to the next step.
|
||
3
|
VERIFY STORED DTC IN INSTRUMENT CLUSTER
• Switch the ignition off, then ON (engine off).
• Retrieve the instrument cluster DTC using the M-MDS.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
Go to the next step.
|
||
4
|
INSPECT INSTRUMENT CLUSTER BACKUP VOLTAGE CIRCUIT
• Switch the ignition off.
• Remove the MAIN 200 A fuse, ROOM 25 A fuse and INTERIOR 10 A fuse.
• Inspect the MAIN 200 A fuse, ROOM 25 A fuse and INTERIOR 10 A fuse.
• Is there any malfunction?
|
Yes
|
Replace the malfunctioning fuse.
Switch the ignition ON (engine on) and wait for 10 s or more.
Switch the ignition off.
Go to the next step.
|
No
|
Replace the instrument cluster, then go to the next step.
|
||
5
|
VERIFY DTC TROUBLESHOOTING COMPLETED
• Always reconnect all disconnected connectors.
• Start the engine.
• Stop the engine.
• Clear the DTC from the PCM memory using the M-MDS.
• Perform the KOER self test.
• Is the PENDING CODE for this DTC present?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the PCM.
Go to the next step.
|
No
|
Go to the next step.
|
||
6
|
VERIFY AFTER REPAIR PROCEDURE
• Perform the “AFTER REPAIR PROCEDURE”.
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
No
|
DTC troubleshooting completed.
|