PID/DATA MONITOR TABLE [ELECTRONIC 4WD CONTROL SYSTEM]
id0302a6134200
|
Monitor item |
Unit/Operation |
Test condition |
Specification (Reference) |
Inspection item |
|---|---|---|---|---|
|
M-MDS display |
||||
|
AAT
|
°C, °F
|
This PID indicates ambient air temperature.
|
• Inspect the ambient air temperature sensor.
|
|
|
APP
|
%
|
This PID indicates accelerator pedal position.
|
• Inspect the accelerator pedal position sensor.
|
|
|
CAL_TABLE
|
—
|
This PID indicates 4WD calibration table.
|
—
|
|
|
CUP_SOL
|
%
|
This PID indicates 4WD solenoid duty cycle.
|
• Inspect the 4WD control module.
|
|
|
GEAR
|
Unknown/1st/2nd/3rd/4th/5th/6th/7th/8th/Not in P/Park/Neutral/Drive/Reverse
|
This PID indicates gear position.
|
• Inspect the PCM.
|
|
|
OIL_TEMP
|
°C, °F
|
This PID indicates differential oil temperature.
|
• Inspect the differential oil temperature sensor.
|
|
|
RPM
|
RPM
|
This PID indicates engine speed.
|
• Inspect the PCM.
|
|
|
SHIFT
|
2Posions/P/R/N/D/S(2)/L(1)/-
|
This PID indicates select lever position.
|
• Perform the DTC inspection for the TCM.
|
|
|
TORQUE
|
Nm
|
This PID indicates total wheel torque.
|
—
|
|
|
VPWR
|
V
|
This PID indicates power supply voltage for 4WD control module.
|
• Inspect the battery.
(See BATTERY INSPECTION.)
• Inspect power supply circuit (ignition switch, IG1 relay, fuse etc.)
(See PUSH BUTTON START INSPECTION.)
(See RELAY INSPECTION.)
|
|
|
WARN_LAMP
|
OFF/ON/Blinking
|
This PID indicates 4WD warning light status.
|
• Inspect the 4WD control module.
|
|
|
WSPD_LF
|
KPH, MPH
|
This PID indicates wheel speed.
|
• Inspect the DSC HU/CM.
(See DSC HU/CM INSPECTION.)
|
|
|
WSPD_LR
|
KPH, MPH
|
This PID indicates wheel speed.
|
• Inspect the DSC HU/CM.
(See DSC HU/CM INSPECTION.)
|
|
|
WSPD_RF
|
KPH, MPH
|
This PID indicates wheel speed.
|
• Inspect the DSC HU/CM.
(See DSC HU/CM INSPECTION.)
|
|
|
WSPD_RR
|
KPH, MPH
|
This PID indicates wheel speed.
|
• Inspect the DSC HU/CM.
(See DSC HU/CM INSPECTION.)
|
|