DTC U0428:00 [ELECTRIC POWER STEERING (EPS)]

id0602a1818500

DTC U0428:00	Signal error to SAS control module
DETECTION CONDITION	• Error detected in signal from SAS control module via CAN communication
FAIL-SAFE FUNCTION	• Refer to “Fail-safe Function Table”. (See DTC TABLE [ELECTRIC POWER STEERING (EPS)].)
POSSIBLE CAUSE	• SAS control module malfunction
SYSTEM WIRING DIAGRAM	Not applicable

Diagnostic Procedure

Step	Inspection		Action
1	VERIFY SAS CONTROL MODULE DTC • Using the M-MDS, perform the SAS control module DTC inspection. (See DTC INSPECTION [SAS CONTROL MODULE].) • Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE].) DTC troubleshooting completed, then go to the next step.
1		No	Go to the next step.
2	VERIFY DTC TROUBLESHOOTING COMPLETED • Using the M-MDS, clear the DTC from the EPS control module. (See CLEARING DTC [ELECTRIC POWER STEERING (EPS)].) • Using the M-MDS, perform the EPS control module DTC inspection. (See DTC INSPECTION [ELECTRIC POWER STEERING (EPS)].) • Is the same DTC present?	Yes	Replace the SAS control module. (See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
2		No	DTC troubleshooting completed.