WASHER FLUID-LEVEL SENSOR INSPECTION

id091900801900

1.  Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION.)

2.  Remove the seal board upper. (See SEAL BOARD UPPER REMOVAL/INSTALLATION.)

3.  Remove the front bumper. (See FRONT BUMPER REMOVAL.) (See FRONT BUMPER INSTALLATION.)

4.  Disconnect the connector. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION.)

5.  Verify that the continuity between the washer fluid-level sensor terminals is as indicated in the table.

ac9wzw00003519

ac9uuw00007307

•  If not as indicated in the table, replace the washer fluid-level sensor. (See WASHER FLUID-LEVEL SENSOR REMOVAL/INSTALLATION.)