DTC U3003:17 [ADAPTIVE LED HEADLIGHTS CONTROL MODULE]
id1502c1003400
|
Description |
Adaptive LED headlights control module high power supply voltage input |
|---|---|
|
Detection condition
|
• Adaptive LED headlights control module power supply circuit voltage of 18.1 V or more is detected for 5 s or more with the ignition switched ON (engine off or on).
|
|
Fail-safe
|
• The headlight leveling actuator is stopped at the position when the malfunction is determined.
|
|
Possible cause
|
• DTCs are stored in the PCM.
• Battery malfunction
• Generator malfunction
• Adaptive LED headlights control module malfunction
|
|
System wiring diagram
|
Not applicable
|
Diagnostic Procedure
|
Step |
Inspection |
Action |
|
|---|---|---|---|
|
1
|
VERIFY PCM DTCs
• Retrieve the PCM DTCs using the M-MDS.
• Is the DTC displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
Go to the next step.
|
||
|
2
|
INSPECT BATTERY
• Inspect the battery.
(See BATTERY INSPECTION.)
• Is the battery normal?
|
Yes
|
Go to the next step.
|
|
No
|
Recharge or replace the battery, then go to Step 4.
(See BATTERY REMOVAL/INSTALLATION.)
|
||
|
3
|
INSPECT GENERATOR
• Inspect the generator.
• Is the generator normal?
|
Yes
|
Go to the next step.
|
|
No
|
Replace the generator, then go to the next step.
|
||
|
4
|
VERIFY THAT REPAIRS HAVE BEEN COMPLETED
• Clear the adaptive LED headlights control module DTCs using the M-MDS.
• Switch the ignition ON (engine off or on) and wait for 5 s or more.
• Retrieve the adaptive LED headlights control module DTCs using the M-MDS.
• Is the same DTC displayed?
|
Yes
|
Repeat the inspection from Step 1.
• If the malfunction recurs, replace the adaptive LED headlights control module, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
5
|
VERIFY IF OTHER DTCs DISPLAYED
• Are any other DTCs displayed?
|
Yes
|
Repair the malfunctioning part according to the applicable DTC troubleshooting.
|
|
No
|
DTC troubleshooting completed.
|
||