NO.18 COOLING SYSTEM CONCERNS-RUNS COLD [SKYACTIV-G 2.5T]


id0103q4802400

18

COOLING SYSTEM CONCERNS-RUNS COLD

DESCRIPTION
•  Engine does not reach normal operating temperature.
POSSIBLE CAUSE
•  Improper indication of low engine coolant temperature indicator light and/or high engine coolant temperature warning light
?  ECT sensor malfunction
?  Instrument cluster malfunction
•  Cooling fan system malfunction
•  Thermostat malfunction (stuck at fully open)
•  Foreign material penetration in engine coolant

Diagnostic Procedure

STEP

INSPECTION

RESULTS

ACTION

1
DETERMINE IF MALFUNCTION CAUSE IS HVAC SYSTEM OR ENGINE
•  Is a customer complaint “Lack of passenger compartment heat” only?
Yes
Inspect the A/C heater system.
Repair or replace the malfunctioning part according to the inspection results.
No
Go to the next step.
2
VERIFY IDLE SPEED
•  Does the engine speed continue at fast idle?
Yes
Perform the symptom troubleshooting “NO.9 FAST IDLE/RUNS ON”.
No
Go to the next step.
3
INSPECT ECT SENSOR SIGNAL
•  Access the ECT PID using the M-MDS.
•  Compare the ECT PID and low engine coolant temperature indicator light and high engine coolant temperature warning light operation.
•  Is the ECT PID value same as indicator/warning light readings?
Yes
Go to the next step.
No
Inspect the ECT sensor.
•  If there is any malfunction:
•  If there is no malfunction:
?  Perform the instrument cluster symptom troubleshooting “LOW ENGINE COOLANT TEMPERATURE INDICATOR LIGHT/HIGH ENGINE COOLANT TEMPERATURE WARNING LIGHT ILLUMINATES OR FLASHES CONTINUOUSLY”.
4
INSPECT COOLING FAN CONTROL SYSTEM OPERATION
•  Perform the Cooling Fan Control System Inspection.
•  Does the cooling fan control system operate properly?
Yes
Go to the next step.
No
Repair or replace the malfunctioning part according to the inspection results.
5
INSPECT THERMOSTAT
•  Cool down the engine.
•  Remove the thermostat.
•  Inspect the thermostat operation.
•  Is there any malfunction?
Yes
Replace the thermostat.
No
Reinstall the thermostat, then go to the next step.
6
VERIFY THAT NO FOREIGN MATTER IS IN ENGINE COOLANT
•  Drain the engine coolant.
•  Has foreign matter penetrated the engine coolant?
Yes
Replace the engine coolant.
No
Go to the next step.
7
Verify the test results.
•  If normal, return to the diagnostic index to service any additional symptoms.
•  If a malfunction remains, inspect the related Service Information and perform the repair or diagnosis.
?  If the vehicle is repaired, troubleshooting is completed.
?  If the vehicle is not repaired or additional diagnostic information is not available, replace the PCM.